>>1013344
Thanks, I explained it poorly ("Rings have to be empty inside") I guess since that inner part of rings isn't needed, but in your picture it looks like it's really easy to just remove it so it still looks great.
> use the cutter locked to one axis to get one of the end's verts in line and snap the others to it
Wdym by "cutter"? Do you cut the big ring here?
> duplicate to make a half-ring
Do you refer to small rings as half rings? I made rings in OP by doing cylinder, selecting top and bottom, inset and then bridge faces. Not sure if there is problem with this, or it's just two ok ways to do the same thing.

Back | Go to board

Board:

/3/

Thread:

This is rough sketch/blockout of something I need in my scene. Rings have to be empty inside ofc. What do you think are the best ways to model this?…