>>2792798
>Any advice on how to get it past without damaging?
The broken part is plastic (soft)
The plumbing part is brass or copper or steel (not as soft)
Use a boning knife or similar tool with the sharp edge toward the center and the back of the blade against the plumbing threads.
As you tap on the tool driving it into the plastic, the plastic will split.
Use an icepick or similar tool on one side of the split to pull the plastic away from the threaded plumbing part.
Once the plastic is away from the threads on one side, use a pair of needle-nose pliers to twist the plastic part to a smaller diameter ane pull it out of the plumbing part.

Back | Go to board

Board:

/diy/

Thread:

Hey smart and strong fellas. Didn’t see a plumbing thread. I have an issue where my shower head rod (plastic) snapped off in my supply pipe in the…