>>2924164
>>2924165
>>2924778
>drilling into a 5cm pvc elbow and hooking it to a straight pipe.
This is what I was going to suggest but it depends on the od of the camera and the id of the elbow. I don't know commie units and have no point of reference for size but it looks like it might be a 1 1/2" or 2" in freedom units. If the fit is tight enough that would probably work. I'd probably drill 3 holes through the elbow and epoxy some nuts to the outside. Then you could use the same socket cap screws. If you're worried about damaging the camera you might be able to use nylon bolts but of those strip or wont get tight enough use metal bolts and put a piece of rubber on the end of them. Maybe a little piece of heat shrink tube. You can get a pvc wall flange to attach to the other side of the pipe so you can actually mount it to a wall. Depends on fit, if it's too loose you'll probably have a bad time with it. You probably won't have an easy time lining it up right to begin with but if thay's so you could probably put some molding putty in the pipe to help cradle it while you tighten the bolts.

Back | Go to board

Board:

/diy/

Thread:

alternative for hikvision dome camera mount