>mountain and valley fold along the neck to form the head and beak
>flip the model over. fold the horizontal fold from earlier back. after this, you can optionally curl it
>fold the paper across the main diagonal
>fold the paper back down (with this, I just folded back around 1/4 of the trapezoid height)
>flip the model over again. make cuts for the wings. on the bottom tail section, trim the sides off to be similar in width to the head, then remove the trimmings (watch out for any little bits that are still barely connected to the wings). then make cuts for the tail feathers

Back | Go to board

Board:

/po/

Thread:

ID this origami bird?